Bad devices from bad makers are ready to conquer the world!

Printing rubber

We have been asked to try to print this soft rubber filament.
At first, we were quite scared because it’s difficult to print soft and rubber-like filaments (this is a very soft Thermoplastic polyurethane), moreover, our printer uses a bowden system to bring the filament to the nozzle hot end…
but after the first test, reducing speed and retraction, we come out with a good setting and voilĂ !

Rubber1

We print nice flowers, bracelets and a nice bouncing ball (in 2 half, glued togheter)

Rubber5

Rubber3

We can print also nice things like this custom mi-band bracelet in the video :)

Rubber4

The video was a bet; when we recorded it, we were not sure about the result, so we are still astonished that all goes well :)

admin

No Comments

Leave a reply

Utilizzando il sito, accetti l'utilizzo dei cookie da parte nostra. maggiori informazioni

Questo sito utilizza i cookie per fonire la migliore esperienza di navigazione possibile. Continuando a utilizzare questo sito senza modificare le impostazioni dei cookie o clicchi su "Accetta" permetti al loro utilizzo.

Chiudi